Coil-wound strip brushes
These are produced by spirally winding a metal strip brush either loosely or around a core.
Winding coil to coil achieves maximum brush density (see photo). The alternative is to wind to a pitch, leaving a defined spacing in between.
For core winding, it is possible to use a shaft supplied by the customer. Of course, we also offer complete cylinders, including shafts, manufactured from a variety of different materials.
Information
Metal strip brushes
In the case of metal strip brushes, the filaments are clamped in a metal spine (either galvanized or stainless steel).
The benefit of this type of production is the brush density, since the fill is continuous without a gap.
Depending on the brush type, all fill materials are possible.
